Re: 8ba Cylinder sleeves
I had a similar problem with a block with all 8 cylinders selves with 1/8" sleeve, I removed them and had the block sonic tested. Still had over 175" in it's thinnest area.
I try to bore all my blocks .125" if possable or to 3 5/16, This gives 258ci with a stock Ford crank and makes a great street engine especially with a milled EAB or 81A head. Compression would be near 8:1. A 2GC carb on a merck intale opened up for it and you have an inexpensive street engine that would be hard to beat . Even get great mileage.
|