The Ford Barn - View Single Post

Bored&Stroked · 08-23-2019, 08:51 PM

Also, do you have the wires in the block or the heads? And - do you have receiver grooves in the opposite side (for the copper to deflect into). A lot of flathead guys seem to put wire in one side or the other . . . and then don't put in the necessary receiver grooves in the other side. Obviously this all requires CNC machines and correct indexing (so the grooves all line up). Let me know what you're up too.

08-23-2019, 08:51 PM	#7
Bored&Stroked Senior Member Join Date: Jan 2011 Location: Central Ohio Posts: 5,073	Re: solid copper head gaskets Also, do you have the wires in the block or the heads? And - do you have receiver grooves in the opposite side (for the copper to deflect into). A lot of flathead guys seem to put wire in one side or the other . . . and then don't put in the necessary receiver grooves in the other side. Obviously this all requires CNC machines and correct indexing (so the grooves all line up). Let me know what you're up too.