The Ford Barn - View Single Post - How do I measure a small piston to head clearance

my4dv8 · 07-02-2016, 02:57 AM

Well there is a stand up offer right there , top man Brian.

I bought some edelbrock heads on our local auction site , my bad never looked closely at them till a few months later and the seller was an outright liar, someone had used a hole saw to cut around several studs to attempt to remove them, result un useable. No they were not a bargain price.

Bluebell tell us more about your flathead, it sounds cool.

07-02-2016, 02:57 AM	#7
my4dv8 Senior Member Join Date: Aug 2010 Location: New Zealand Posts: 1,112	Re: How do I measure a small piston to head clearance Well there is a stand up offer right there , top man Brian. I bought some edelbrock heads on our local auction site , my bad never looked closely at them till a few months later and the seller was an outright liar, someone had used a hole saw to cut around several studs to attempt to remove them, result un useable. No they were not a bargain price. Bluebell tell us more about your flathead, it sounds cool. Last edited by my4dv8; 07-02-2016 at 03:17 AM.