The Ford Barn - View Single Post

alanwoodieman · 07-05-2019, 01:45 PM

I took a short length of plastic pipe 2" x 10" put cap on one end drilled for a fitting that matched the oil pressure fitting in the block, put a screw in plug on the other end with a air hose hole--attach hose to block, fill pipe with oil, screw in plug, blow low pressure air thru the hole 30lbs and that pushes the oil into the engine

07-05-2019, 01:45 PM	#5
alanwoodieman Senior Member Join Date: May 2010 Location: upstate SC Posts: 2,963	Re: Priming engine with oil I took a short length of plastic pipe 2" x 10" put cap on one end drilled for a fitting that matched the oil pressure fitting in the block, put a screw in plug on the other end with a air hose hole--attach hose to block, fill pipe with oil, screw in plug, blow low pressure air thru the hole 30lbs and that pushes the oil into the engine