Thread
:
shimming engine bearings
View Single Post
05-22-2015, 10:24 AM
#
4
Kohnke Rebabbitting
Senior Member
Join Date: May 2010
Location: 60615,330th Ave.,Clare, Iowa, 50524
Posts: 1,457
Re: shimming engine bearings
.001-50 Minimum, or plus .000-50 Maximum, which is a .001 per inch of crank diameter.
.001 thousandths was used when the engine was run in cold under another power source.
Kohnke Rebabbitting
View Public Profile
Send a private message to Kohnke Rebabbitting
Find More Posts by Kohnke Rebabbitting