The Ford Barn - View Single Post

40cpe · 11-13-2019, 10:42 AM

I'm not a welding expert, but I have an O/A set up for my use in my shop. I've learned that you can put too large a rosebud on your torch and the acetylene can't produce gas fast enough to fuel the torch. The torch will pop and go out. I read the question and answer section of the link you provided and an answer by Lincoln said "There is not a rosebud heating tip available this this kit."

11-13-2019, 10:42 AM	#167
40cpe Senior Member Join Date: May 2010 Location: Star, MS Posts: 4,024	Re: 36 Ford drag link orientation question I'm not a welding expert, but I have an O/A set up for my use in my shop. I've learned that you can put too large a rosebud on your torch and the acetylene can't produce gas fast enough to fuel the torch. The torch will pop and go out. I read the question and answer section of the link you provided and an answer by Lincoln said "There is not a rosebud heating tip available this this kit."