The Ford Barn - View Single Post

Brentwood Bob · 10-15-2010, 12:22 AM

the latch assembly should still be held in place by the 4 screws that hold it to the door frame. The door handle needs to be held in the open position. the 2 exterior screws that hold the bezel on the exterior of the door are taken completely out. If the handle won't jiggle loose in the open position, then you need to drive it out from the interior side of the door. I held the latch in, or have an assistant do that while you tap out the handle. I used a 8 inch long 1/4 in dia brass rod.

10-15-2010, 12:22 AM	#8
Brentwood Bob Senior Member Join Date: May 2010 Location: brentwood, ca Posts: 4,233	Re: removing outside door handle the latch assembly should still be held in place by the 4 screws that hold it to the door frame. The door handle needs to be held in the open position. the 2 exterior screws that hold the bezel on the exterior of the door are taken completely out. If the handle won't jiggle loose in the open position, then you need to drive it out from the interior side of the door. I held the latch in, or have an assistant do that while you tap out the handle. I used a 8 inch long 1/4 in dia brass rod.