View Single Post
Old 06-20-2018, 07:45 PM   #4
leon bee
Senior Member
 
Join Date: May 2017
Location: Arkansas
Posts: 611
Default Re: 8BA Flywheel/Clutch....I've Read TOO Much

Alright, thanks to you guys.....I'll think 10 inch. I believe I bookmarked an old post from here or the Hamb which shows the hole measurements for the correct flywheel. I'll be at my shop tomorrow to look at stuff.

What's confusing right now, sitting here, is what Mac says. The old friction disc I slid on my new 3 speed is what was replaced by a 9 1/2" setup for my coupe. A whole new clutch from Mac himself. So that's all assembled now and works great.

But here I am with an old nasty 9 1/2 disc off that car which fits right on my new top load 3 speed shaft. Which Mac says just ain't right. I didn't offer up the pressure plate to it. But what Mac says indicates the shaft going into that trans is different than it oughta be.

All good, I love talking about this stuff.
leon bee is offline   Reply With Quote