[triumphleroy]

I have a full set of stock wheels and 55 Ford Full Hubcaps, These are just a set of aftermarket Rally Wheels similar to Chevrolet rally Wheels. I am having an small vibration at about 45 mph, and this set of wheels has two bolt patterns so moved them onto this Ford for Diagnostic reasons ? have had drive shaft balance checked, set pinion angle on rear end, swapped rear center section, changed from 4 cylinder T5 to 8 cylinder T5? Can coast down from 60 with engine shut down and goes through that vibration from 48 mph back through 37 mph worst at 45 mph? Trying to set up Balance with the old Bear Type Balance where it is spun up on the vehicle???