The Ford Barn - View Single Post - Aug/Sept project 2 to make 1 39 std cpe on sdn pan

'36 5W · 09-06-2020, 10:00 PM

Good advice from tub^^^. You may find the body a bit tweaked,
so door gaps will be a good place to start. Take many measure-
ments to be sure body AND frame are square, before and after bolting body down to frame.

Hell of a project to be tackling alone; you must have ice in your
veins and nerves of steel!

09-06-2020, 10:00 PM	#20
'36 5W Senior Member Join Date: Aug 2010 Location: Vancouver, Wa. Posts: 193	Re: Aug/Sept project 2 to make 1 39 std cpe on sdn pan Good advice from tub^^^. You may find the body a bit tweaked, so door gaps will be a good place to start. Take many measure- ments to be sure body AND frame are square, before and after bolting body down to frame. Hell of a project to be tackling alone; you must have ice in your veins and nerves of steel! Last edited by '36 5W; 09-09-2020 at 11:02 AM.