View Single Post
Old 02-13-2014, 09:50 AM   #106
PeterC
Senior Member
 
PeterC's Avatar
 
Join Date: May 2010
Location: Connecticut
Posts: 735
Default Re: Harmon Collins Rotors ?????

" and plug gap is .025" so 'Cap terminal' to 'Rotor terminal' clearance is important; that clearance between the brass electrodes on each side of the rotor (180 degrees apart) is important"

Interesting because there was a separate thread recently about sloppy repro cap clearance on the normal crab caps - wide variations - Bubba said he gets caps that are better than most - but not sure how they stack up to the original tolerances that Henry demanded.
PeterC is offline   Reply With Quote