View Single Post
Old 01-15-2014, 04:25 PM   #88
Senior Member
Join Date: May 2010
Location: Sydney, Australia
Posts: 948
Default Re: Harmon Collins Rotors ?????

An outstanding effort, well done!

Are you able to install Ejector Pins on your mould to help remove the parts without damaging them. I may be talking thru my hat as I'm not familiar with Injection Moulds, but I have done a lot of Drop Forging, and on some dies the only way to remove a forging is with Ejector Pins.
Fe26 is offline   Reply With Quote