View Single Post
Old 12-19-2018, 01:49 PM   #15
holdover
Senior Member
 
Join Date: May 2011
Location: SW Virginia near the Blue ridge Parkway
Posts: 527
Default Re: New video on How to Do a Lube Job on a Model A Ford

those of you that have the old style fittings and use the adapter on your grease gun, soon discover that a lot of grease does not go where it is suppose to. If you put a very small O ring in the adapter, then apply it to the fitting pushing slightly on the grease gun, it will work about as good as a modern three prong gun fitting. Those of you with a lathe can use a modified bit to cut a small recess to hold the O ring in place
holdover is offline   Reply With Quote