View Single Post
Old 12-18-2018, 08:51 PM   #14
Senior Member
Y-Blockhead's Avatar
Join Date: Jul 2011
Location: Redondo Beach, CA
Posts: 3,776
Default Re: New video on How to Do a Lube Job on a Model A Ford

Nice video Mark and Christine. I know it is "not on the list" but may I suggest lubing your springs also? I use B'laster Dry Graphite on my springs. Be careful of overspray tho. It is difficult to get off. improves the ride.

Don't over do it on the throw out bearing. Most throw out bearings available these days are sealed. Any grease you pump in there only lubes the trans snout/bearing hub.
'30 Briggs Town Sedan
'55 Ford Ranchwagon
And once again that is just my 1 worth.

Last edited by Y-Blockhead; 12-18-2018 at 09:00 PM.
Y-Blockhead is offline   Reply With Quote