Thread: New block
View Single Post
Old 05-18-2017, 06:23 PM   #175
Tod
Senior Member
 
Join Date: Mar 2014
Location: Salem, Ohio
Posts: 881
Default Re: New block

Quote:
Originally Posted by Tod View Post
I'll see what I can do about the oiling, but if I make a galley through the lifter bores it only helps if the lifters used are able to allow oil flow all the way through. I don't think stock lifters allow that, do they? I may have to make a galley so that when the lifter bores are cut it cuts into the galley some, allowing oil to pass along the side of the lifter. Kind of like the Clevelands were.

Not sure yet how I will do all three mains. The cam journals can be oiled from the top. A boss above each journal is drilled down through a top/center galley and then plugged with a 1/8 NPT plug.

Tod
I think I have main journal oiling figured out!!! I will know for sure as my new model takes shape. I started on it today and the front is pretty far along.

Tod
Tod is offline   Reply With Quote