[DHZIEMAN]

There is a need to get to the cause! That takes a bit of effort with a voltmeter and an ohm meter! You can also set up a little test bench with 6 volts applied on the coil, with a condenser across the connection wires and open the wires (what maybe a paper clip in the center high voltage port to one of the terminals, and when you open the wire if you can get a good solid quarter inch spark, you coil and capacitor are OK. If not, it is one or the other, Coil or capacitor. If it is not the coil or capacitor, then you need to reinstall, and start checking with a voltmeter for continuity and open circuits not getting power and ground to the coil. Good luck