The Ford Barn - View Single Post

OLD...BILL · 05-31-2011, 07:42 PM

I think your going to find the ( add it plug ) in the passage, that was drilled for the 95 % filtering system, see the diagram in rotowrench therad it is called; "the 7/16 allen head set screw," if it is in place the oil goes out to filter ands pressure gage and returns to cam and the two main bearings, with no oil filter in service, the out let is pluged, oil stays in the pump shaft / bore area and goes to the rear main ONLY.... this is sad.... We may all learn from it, ..hope this helps, sorry....OLD....BILL

05-31-2011, 07:42 PM	#48
OLD...BILL Senior Member Join Date: May 2010 Location: Northern California,coast Posts: 552	Re: Engine seized 2 miles after rebuild I think your going to find the ( add it plug ) in the passage, that was drilled for the 95 % filtering system, see the diagram in rotowrench therad it is called; "the 7/16 allen head set screw," if it is in place the oil goes out to filter ands pressure gage and returns to cam and the two main bearings, with no oil filter in service, the out let is pluged, oil stays in the pump shaft / bore area and goes to the rear main ONLY.... this is sad.... We may all learn from it, ..hope this helps, sorry....OLD....BILL