The Ford Barn - View Single Post

DavidG · 02-26-2011, 05:30 PM

Gary,

Yes, '32-'36 water pump pulleys are the same (except early '32 pulleys which were shorter from front to back) although some of the pulleys supplied for post-production service were pressed on rather than held in place on the shaft with a tapered pin. Obviously those without the holes for the tapered pin have a slightly smaller inside diameter for a press fit. There were minor differences in the pulleys in terms of casting marks (some have part numbers, some don't) and some NORS pulleys have more pronounced differences in the shape of the front part of the pulley.

Dave

02-26-2011, 05:30 PM	#4
DavidG Senior Member Join Date: May 2010 Location: southeastern Michigan Posts: 10,104	Re: 32 Tall water pump pulleys Gary, Yes, '32-'36 water pump pulleys are the same (except early '32 pulleys which were shorter from front to back) although some of the pulleys supplied for post-production service were pressed on rather than held in place on the shaft with a tapered pin. Obviously those without the holes for the tapered pin have a slightly smaller inside diameter for a press fit. There were minor differences in the pulleys in terms of casting marks (some have part numbers, some don't) and some NORS pulleys have more pronounced differences in the shape of the front part of the pulley. Dave