The Ford Barn - View Single Post

DavidG · 09-15-2019, 11:24 AM

A countersunk washer would be required and it would leave the bolt higher than original, which depending on the thickness of the washer might be high enough to leave little or no threads for the hex nut after allowing for the thickness of a lock washer (on the bottom end of the special bolt).

09-15-2019, 11:24 AM	#24
DavidG Senior Member Join Date: May 2010 Location: southeastern Michigan Posts: 10,103	Re: transmission floor cover A countersunk washer would be required and it would leave the bolt higher than original, which depending on the thickness of the washer might be high enough to leave little or no threads for the hex nut after allowing for the thickness of a lock washer (on the bottom end of the special bolt).