Re: Spark Plug Leads Change 34
Carl, I have just done two of these, one on the bench the other in the car, in car what I did was to take all the old leads out, then solder the terminal on that is on the terminal plate end, feed that in through the harness and then cut it to length on the plug end roughly leaving a bit to play with, then do the rest , I feed them in from the dist end one at a time, then cut them to length at the plug end and terminate them there.
ALSO another way I do it some times is I have a terminal plate which I have drilled out through the holes where the wires go in, then I can feed in the wire from the spark plug eng with the plugs ends already on,get the length right by feeding them into the terminal plat that I have drilled out,and cut the off and terminate the dist end.
Lawrie
|