[sugarmaker]

David, Ford Folks,
As I get a little older and maybe a little wiser and a little slower I tend to ask more questions. Your post about the details of removing engine and transmission #231
I will start to look at this today a little. Do you remove the angled portion of the wooden floor board for a little more room? I have never been into one of these with the enclosed drive shaft. I dont know anything about them other that the fact someone put them together so they will come apart.
Going out to do some cleaning and review of that area.
I understand removing the top from the transmission. for clearance.
Will pad the front cross member.
The two engine mount bolts supports (rubber) have been removed from the engine support bracket in the front.
The cup on the torque tube I dont understand yet, but will learn buy looking.
Just dont want to break anything, so will go slow and not force anything.
1932 Model B engine and tranny removal is the goal over the next few days.
What is the feature/s that tells you the head was changed?
Keeping my fingers crossed that the existing block and components will be good cores for a rebuild.
Regards,
Chris