Finally starting my ‘35’s juice brake conversion
Collected all parts required (‘47 ford parts), all parts new or cleaned up refreshed. Got a few questions:
1-Is arcing the shoes really necessary? I’ve read the new replacement shoes fit & roundness is adequate to put on as is & break-in as done on newer vehicles I.e. late ‘60’s cars?
2-I’m using the ‘47 brakes all around as I have & r good with plans to convert to Lincoln Bendix type in front when $ allow. Will the Bendix type fit on direct swap when I do?
3-I’m using Richard’s Early Ford Garage Juice brake conversion kit ( uses existing brake pedal & linkage to single well ‘47 Master Cylinder. Any heads up on issues from anyone who used this set up on vehicle with fully assemble car I.e body on, engine / tranny in, interior in etc. would be appreciated!
__________________
Nomad
|