Hi,
Do you know what the dimensions of John Connolly’s sleeve are? I’d like to have that so I could ask the shop about how much grinding is involved although as said, setup time would take the most.
Thanks,
Glenn
Quote:
Originally Posted by skidmarks
You dont need a super large lathe. About a 18" swing. I ve done them with a carbide tool bit. Center the bell end in a 4 jaw chuck and made a pilot for the wheel bearing end. And dial it in. Takes longer to set it up then maching it
You need to get the replacement sleaves from the columbia rear guy which a thinner then the ones mac sells. Interference fit and press them on
|