The Ford Barn - View Single Post

Kube · 03-14-2021, 08:08 AM

Ken, I believe I am the only one that has ever bothered. And now you? I'm so proud of you!

I secure the board to a flat surface with a straight edge. A table will do. I measure out and lightly mark where I want my indentations to be placed. About ten per inch.
Using a T-Square and a dulled alignment punch, I "press" the indentations in.
At this very moment, it occurred to me a "dulled" pizza cutter may work better / easier.

03-14-2021, 08:08 AM	#2
Kube Senior Member Join Date: May 2010 Location: Wisconsin, USA Posts: 9,015	Re: Original 40 kick panels Ken, I believe I am the only one that has ever bothered. And now you? I'm so proud of you! I secure the board to a flat surface with a straight edge. A table will do. I measure out and lightly mark where I want my indentations to be placed. About ten per inch. Using a T-Square and a dulled alignment punch, I "press" the indentations in. At this very moment, it occurred to me a "dulled" pizza cutter may work better / easier. __________________ "I can explain it for you. However, I can't understand it for you".