The Ford Barn - View Single Post - KR Wilson Essential Tools for Flathead V8's

Brian · 01-04-2020, 04:17 PM

Good for you Karl. When I mentioned crankhandle/lugwrench, I only use the crankhandle....Should I need to remove a wheel etc, I'll always use modern tools; better fit, less chance off rounding off bolts etc.

In all honesty, I find I seldom need to put a wrench near my heap....probably the most used would be a 1/2" R&OE, used for r&r of distributor...
The most used tool would undoubtedly be a grease gun; I am big on lubrication....

01-04-2020, 04:17 PM	#34
Brian Senior Member Join Date: May 2010 Location: Masterton, New Zealand Posts: 3,834	Re: KR Wilson Essential Tools for Flathead V8's Good for you Karl. When I mentioned crankhandle/lugwrench, I only use the crankhandle....Should I need to remove a wheel etc, I'll always use modern tools; better fit, less chance off rounding off bolts etc. In all honesty, I find I seldom need to put a wrench near my heap....probably the most used would be a 1/2" R&OE, used for r&r of distributor... The most used tool would undoubtedly be a grease gun; I am big on lubrication.... __________________ Unfortunately, two half wits don't make a whole wit!