View Single Post
Old 01-04-2020, 03:44 PM   #17
Ronnieroadster
Senior Member
 
Ronnieroadster's Avatar
 
Join Date: Dec 2010
Location: East Coast in CT
Posts: 1,529
Default Re: crab distributor setup

Quote:
Originally Posted by the99car View Post
I've got pertronix in my '48(was in it when I bought it) and just got one for my '46. Instructions don't tell how to time it. do you just install , start it and "fine tune" with the slight adj on the side. Kenny -Z Hills



Yes thats exactly what you do. However I go a bit farther I increase the slot opening a bit more so additional timing adjustment can be accomplished. Being a Hot Rodder i always try to improve where i can and you might even experience better fuel economy when your done.
Ronnieroadster
__________________
I use the F word a lot no not that word these words Flathead , Focus and Finish.
"Life Member of the Bonneville 200 MPH Club using a Ford Flathead block"
Owner , Builder, Driver of the First Ford Flathead bodied roadster to run 200 MPH Record July 13, 2018 LTA timing association 200.921 in one and a half miles burning gasoline.
First ever gas burning Ford flathead powered roadster to run 200 MPH at Bonneville Salt Flats setting the record August 7th 2021 at 205.744 MPH
Ronnieroadster is offline   Reply With Quote