05-01-2015, 09:00 AM
|
#41
|
Senior Member
Join Date: May 2010
Location: Coral Springs FL
Posts: 10,941
|
Re: 51 Merc v/8 into 40 ford
Quote:
Originally Posted by dixiedelux
Great Help again, Fordy! I plan to use the homemade piece in front of radiator. It is used a lot, isn't it? The panel inside the nose of the hood, I have yet to see. I have the new I outer grill panels #91A-8104/5. I have new inner fender panels. I plan to have my hood louvered. I suppose it would be prudent to drop the panels off with the hood. the problem with that is all of the new Drake paint will have to be removed and I am not sure there is much flat area to louver. Is there an aftermarket vendor for the 40 inner fender panels? How about Mr. 40?
|
The little piece of metal between the radiator and the hood latch bracket is not commonly used. Instead, there is a sheet metal piece that you can buy that fits over the entire opening on top of the grille. It's called a grille shroud and looks like this:
http://www.mr40s.com/mr.-40-s-stuff.html Figure out a way to install it without having to drill holes into your existing sheetmetal brackets. Maybe, use industrial Vel-Cro.
Make your own piece out of thick cardboard, first, to see how it works before spending any $$. Again, try to avoid drilling any holes into your OEM metal.
Last edited by 19Fordy; 05-01-2015 at 09:11 AM.
|
|
|