[duke36]

installed stainless steel sleeves in the center barrels of SW sedan with doors removed from car for new stock type vendor's hinge pins. With no lathe available, etc. we used 5/16" stain. steel thin wall pipe reamed to 9/32" to suit and barrels drilled with 5/16" jobbers bit before placing sleeves using undersize pin as a driving guide. Fussy finesse work needing 2 people and to protect paint, but doors are super tight! A slight taper was needed on pin ends and grind the serrations very slightly then dipped in 600 wt. oil and knock them in.