The Ford Barn - View Single Post

Mart · 08-25-2022, 02:51 PM

I ran the engine for a few miles but have yanked it out as it does not seem happy. I'll have to look at it in more detail when time permits. Installing a plodder motor for the event this weekend.

I will look at adding babbit / white metal. I have no knowledge about it though.

08-25-2022, 02:51 PM	#23
Mart Senior Member Join Date: May 2010 Location: Solihull, England. Posts: 8,766	Re: Excessive crank end float. I ran the engine for a few miles but have yanked it out as it does not seem happy. I'll have to look at it in more detail when time permits. Installing a plodder motor for the event this weekend. I will look at adding babbit / white metal. I have no knowledge about it though.