The Ford Barn - View Single Post

Tom Wesenberg · 04-23-2012, 05:39 AM

"See what I mean? Fun for some is nit picking pain the ass for others. "

I've always wondered where nits were picked?

BTW, this is probably the extreme nitpickin'. I'm wanting to replace a cracked seat in my 1959 Crestliner runabout and I can't find the exact 6 screws that should be used. 12-28 x 1 1/2" oval head phillips drive aluminum screws. I can't even find something close, like stainless 12-24 x 1 1/2".

04-23-2012, 05:39 AM	#25
Tom Wesenberg Senior Member Join Date: May 2010 Location: Mpls, MN Posts: 27,582	Re: Snyder's head machined "See what I mean? Fun for some is nit picking pain the ass for others. " I've always wondered where nits were picked? BTW, this is probably the extreme nitpickin'. I'm wanting to replace a cracked seat in my 1959 Crestliner runabout and I can't find the exact 6 screws that should be used. 12-28 x 1 1/2" oval head phillips drive aluminum screws. I can't even find something close, like stainless 12-24 x 1 1/2". Last edited by Tom Wesenberg; 04-23-2012 at 05:44 AM.