Quote:
Originally Posted by J and M Machine
I just wanted to post this showing the amount removed which I mentioned the other day of.050" which you can see is right where the threads should be in regard to the nut.
The measurment I have is 2.2" .
This block was origninal unmolested when it came through the door so I know that the block height is original.
|
Well I definitely am not doubting your word and will gladly yield to your expertise but I was of the opinion that to be correct, there were to be a thread or two showing out of the top of the nuts. I have included a couple of factory photos to possibly confirm this.
Also, I thought it had been established that the correct stud boss height (dimension taken off of the original print) was to be 2.250" -and not 2.2"?
.