The Ford Barn - View Single Post

jmerson · 05-12-2020, 08:25 PM

I'm sure this has come up in the past but i searched for it and got nothing. I have a '34 sedan with mustang front end. The caliper has a casting number 4109 and an emblem " Ford". It has a 10" rotor that was a 4 bolt rotor but it has been redrilled for 5 studs. I measured it and got 4.25" spacing but maybe i measured wrong because all i can find for 10" is either 5" or 4.75" or 4.5". Any one have any experience with this setup??
I want to get new rotors, calipers and pads.

05-12-2020, 08:25 PM	#1
jmerson Member Join Date: Mar 2012 Location: Waterloo,CA Posts: 50	'75 pinto 10" rotor and caliper I'm sure this has come up in the past but i searched for it and got nothing. I have a '34 sedan with mustang front end. The caliper has a casting number 4109 and an emblem " Ford". It has a 10" rotor that was a 4 bolt rotor but it has been redrilled for 5 studs. I measured it and got 4.25" spacing but maybe i measured wrong because all i can find for 10" is either 5" or 4.75" or 4.5". Any one have any experience with this setup?? I want to get new rotors, calipers and pads.