[rockfla]

It's not an easy task, I found that starting with the two wires to the bottom of the cap first, then the two at the top works best as it relates to the notch in the cap!!! You can bend and fit each wire to the cap and see just how to route it around the center post of the cover and where it best exits the cover hole. Then I found that IF you orient the wires, the two shortest to the front (IF you are looking at the engine from the side of the car) and the two longest behind those, then feed them into the spark plug tube!!! A bend Awl helps a lot once you start feeding the wires into the tube. ALSO make sure and lay out ALL the rubber o-ring, gaskets and rubber boot as not to "FORGET" any of the parts and have to pull it back apart to fix what you left off!!!! Ask how I know about that!!! I hope it's at least clear as mud???