View Single Post
Old 12-17-2019, 01:19 AM   #11
AGBill
Junior Member
 
Join Date: Dec 2010
Location: Arroyo Grande, CA
Posts: 14
Default Re: Transmission gear/shaft question

I had the exact same problem with a new shaft that I purchased from Snyders. The solution for me was to mount the shaft in a small lathe and used some medium grit emery cloth with no lubricant. I spun the shaft and looped the emery cloth around it and removed about 0.002-0.003. The gears then slid on the shaft freely with no problems.
AGBill is offline   Reply With Quote