View Single Post
Old 12-16-2019, 02:01 PM   #6
100IH
Senior Member
 
Join Date: Dec 2011
Location: SW Idaho
Posts: 958
Default Re: Transmission gear/shaft question

Sponsored Links (Register now to hide all advertisements)
If you want to loosen them up or indicate where the rub is, put a very small amount of lapping compound ( fine or extra fine) on the shaft and slide one gear at a time back and forth on the shaft - this is done with the splined shaft and the gear on the bench, not in the housing. Do all of the gears one at a time. Leave no compound after, wash in solvent and soap after the solvent.
100IH is offline   Reply With Quote