View Single Post
Old 12-16-2019, 11:37 AM   #4
rotorwrench
Senior Member
 
rotorwrench's Avatar
 
Join Date: Jun 2010
Location: San Antonio, Texas
Posts: 12,035
Default Re: Transmission gear/shaft question

They should slide but have no rocking play so they have to be a close fit. If they won't slide by hand push fit then the shaft may be a bit oversized. That's fine if gears are worn but not so good if gears have no wear. It's a good idea to check the dimensions the best you can and see where the clearance is the tightest. If it's on the OD of the shaft then that should be no problem but if it's in the splines then that could be a problem.
rotorwrench is offline   Reply With Quote