Re: Need help from the flathead gurus...? Valve clearance issue
You've had a bit of tough luck on this sucker now haven't yah! LOL
I think you're doing the right thing - making sure you have the right parts, right setup, etc.. - stick to it. Also, you're learning a lot and this thread helps others. The only bad part is that it is your wallet and time that are being sucked up in the process. That sucks.
I'd not run flat lifters if it was mine - why compromise at this point? Either have them resurfaced with the correct radius, or find some others. When lifters DON'T rotate, then things wear out in a hurry - so why risk it.
I appreciate that you're keeping a good attitude and not just throwing this engine together with a 'Fxxx It' attitude - in the end, this will benefit you and your engine greatly.
Hang in there . . .
B&S
|