[mike42]

I'm baaack !!

Mart.....where did you get those pins ? I had to grind away a weld puddle in order to remove them from the links.

Also....Did I read somewhere that the spindle should we wiped "very" clean as well as the as the area in drum that the spindle slides into ? I have cleaned the bearing and repacked it and installed the bearing with a new seal and clip that holds it all together..

Today may be my last at decent weather so I want to try and get as much done as possible. Snow is coming along with wind and rain !! Lovely....!

Thx again for all the help.

Mike