The Ford Barn - View Single Post

cuda · 04-13-2012, 08:32 PM

Couldn't it be sufficient to just check the hole sizes with ends of the drill bits? If the next bigger size won't fit and the next smaller size does, wouldn't that make it close enough?

04-13-2012, 08:32 PM	#13
cuda Member Join Date: Sep 2011 Location: Georgia Posts: 55	Re: Zenith carb rebuild Couldn't it be sufficient to just check the hole sizes with ends of the drill bits? If the next bigger size won't fit and the next smaller size does, wouldn't that make it close enough?