[ryanheacox]

As someone who was in your shoes a couple months ago the short answer is not that hard.



I didn't touch the clutch since it's basically new but I did do everything else. I reinstalled mine by myself and heaved it in through the passenger door. Everything slid together without much fighting and then I realized I forgot the throwout bearing... the second time was much harder. Guess I only had enough steam for one run through.


To get the rear end back in place I used a jack under the banjo and a jack under the radius rod to torque tube attachment point. A couple times adjusting the jacks and shuffling things around and everything went right together.