The Ford Barn - View Single Post

Kurt in NJ · 08-07-2018, 02:41 PM

I just drilled a small hole and tapped it 1/2 way between the water hole and the stud hole--- screwed a brass machine screw (10/32?)in as far as it would go, cut it off and peined it flat-- couple of runs with a flat file, that was 30 years ago, still no leaks

08-07-2018, 02:41 PM	#10
Kurt in NJ Senior Member Join Date: May 2010 Location: on the Littlefield Posts: 6,159	Re: Head Crack Between Cylinders 2 & 3 I just drilled a small hole and tapped it 1/2 way between the water hole and the stud hole--- screwed a brass machine screw (10/32?)in as far as it would go, cut it off and peined it flat-- couple of runs with a flat file, that was 30 years ago, still no leaks