The Ford Barn - View Single Post - I'm a bonehead

Andy · 01-30-2019, 12:23 PM

It was a common practice to turn 35-6 housings over to get better bearing surfaces.
There is a drain hole in the bearing web for oil to get back to the center section. You should drill some new ones on the opposite side.

01-30-2019, 12:23 PM	#8
Andy Senior Member Join Date: May 2010 Location: Kerrville, Tx Posts: 2,771	Re: I'm a bonehead - 39 rear end questions It was a common practice to turn 35-6 housings over to get better bearing surfaces. There is a drain hole in the bearing web for oil to get back to the center section. You should drill some new ones on the opposite side.