Quote:
Originally Posted by rockfla
I talked to Mike at Third Gen about this as I am redoing the floor boards and all in our 39 Mercury. I have ordered the trans cover gasket, and the shifter gasket for under the cover BUT according to what I took off, there "seems" to be a "rubberized thread impregnated" gasket/seal attached at three points that "maybe" held the floor mat in place???? and the shifter boot fit over the top of???? ANY Mercury guru's OR possibly 39 Ford guys with an "Idea"???
|
There was no seal or gasket between the mat and the floor board. If there was something there in your car, someone added it.
Two clips held the mat in place - nothing else. One on each side of the transmission pan "tunnel". Repop pans do not have these holes.
The picture I've attached is a '39 standard (no shift boot), but shows the two clips in their proper placement.