Quote:
Originally Posted by Fredb_
Can a person buy one of these restrictor fittings? I'm confused by the last post. The filter shouldn't have 60 lbs of pressure by moving the restrictor to the block fitting. The above illustration shows it just before entering the filter, which would allow full pressure on the line coming from the block. If I move it back to the block this should lower the pressure through the entire filter setup....correct? Anyway, can anyone tell me where I might acquire this special fitting, or do I need to make it? Thanks again.
|
This is an 8BA restrictor fitting (it also accepts the pressure sender) You could solder and drill a suitable fitting for the side of your filter.