The Ford Barn - View Single Post

Terry,NJ · 11-02-2014, 09:23 AM

I used a piece of sheet 18ga. I attached a piece of ash to the bottom. I had cut out a large hole for the cup. I made the sheet metal long enough to reach two of the screws that hold the dash rail! I then slid the cup holder under the dash rail, replaced the screws, and "Viola", My mod. A has a cupholder. The longest part of this project was waiting for the paint to dry!
Terry

11-02-2014, 09:23 AM	#5
Terry,NJ Senior Member Join Date: Nov 2013 Location: Northern Bucks Co. Pa Posts: 632	Re: Cupholder Dash Mount I used a piece of sheet 18ga. I attached a piece of ash to the bottom. I had cut out a large hole for the cup. I made the sheet metal long enough to reach two of the screws that hold the dash rail! I then slid the cup holder under the dash rail, replaced the screws, and "Viola", My mod. A has a cupholder. The longest part of this project was waiting for the paint to dry! Terry