Re: Repro Parts That Don't Fit
The only gripe I have is with the quality of the nuts and bolts supplied. I have had to replace the bolts for tie rod ends and motor mounts this year already. Both were too short and not even to Grade 2 strength where at least Grade 5 is required. Got replacements from local fastener store. Had heck of a job drilling for split pins in Grade 5 bolts. Could not do it in Grade 8 bolts.
Never had a problem other than this with parts supplied by George Moir in Stoney Plain. I will tell Dwayne and Terry about my concerns the next time I drop by.
|