The Ford Barn - View Single Post - Question- RE Mounting The Tudor Body to the Frame

markwilltoo · 12-08-2019, 10:32 AM

All, thanks for the feedback on the frame welting.

Would't the body square up if the holds in the frame and body have not been altered once you get the body bolts in? Where would you check for squareness from, LF to RR mount holes and RF to RR mounting? This would be pretty tough unless the body was suspended in air given all the obstructions in between for a measure tape.

Also, wouldn't you want to get the body set correctly then adjust the radiator?

Thanks.

12-08-2019, 10:32 AM	#5
markwilltoo Junior Member Join Date: Oct 2018 Posts: 12	Re: Question- RE Mounting The Tudor Body to the Frame All, thanks for the feedback on the frame welting. Would't the body square up if the holds in the frame and body have not been altered once you get the body bolts in? Where would you check for squareness from, LF to RR mount holes and RF to RR mounting? This would be pretty tough unless the body was suspended in air given all the obstructions in between for a measure tape. Also, wouldn't you want to get the body set correctly then adjust the radiator? Thanks.