The Ford Barn - View Single Post

Fe26 · 01-15-2014, 04:25 PM

An outstanding effort, well done!

Are you able to install Ejector Pins on your mould to help remove the parts without damaging them. I may be talking thru my hat as I'm not familiar with Injection Moulds, but I have done a lot of Drop Forging, and on some dies the only way to remove a forging is with Ejector Pins.

01-15-2014, 04:25 PM	#88
Fe26 Senior Member Join Date: May 2010 Location: Sydney, Australia Posts: 949	Re: Harmon Collins Rotors ????? An outstanding effort, well done! Are you able to install Ejector Pins on your mould to help remove the parts without damaging them. I may be talking thru my hat as I'm not familiar with Injection Moulds, but I have done a lot of Drop Forging, and on some dies the only way to remove a forging is with Ejector Pins.