Re: Pedal assembly
If the '37 is sim to my '38 you have to enlarge the hole the assembly goes through. I didn't have the template back when I did mine so that was the hardest part. The stock '37 clutch shaft lever will probably be too far right to line up with the '39 clutch pedal linkage. I just made a longer shaft but there are other offset clutch shaft levers that will make everything line up. Also note that the clutch pedal arm may bottom out on the '37 frame. This will limit adjustment. You can make a dimple in the edge of the frame where the clutch pedal arm hits and that will help. I didn't do that but I wished I had after I changed to a diaphragm clutch disc. Could have used the extra wiggle room.
|