The Ford Barn - View Single Post

john in illinois · 09-07-2019, 12:56 PM

I have a 59a that came with the rubber seal. The sleeve shown in Gary's pic is an 8ba part I believe.
I needed to replace the pulley so I parted off the spiral part of a 59 pulley and cut a 45* on the end to match the sleeve. Works fine.

John

09-07-2019, 12:56 PM	#18
john in illinois Senior Member Join Date: May 2010 Location: Illinois Posts: 2,184	Re: Crank pulley Question I have a 59a that came with the rubber seal. The sleeve shown in Gary's pic is an 8ba part I believe. I needed to replace the pulley so I parted off the spiral part of a 59 pulley and cut a 45* on the end to match the sleeve. Works fine. John __________________ Welcome each day Last edited by john in illinois; 09-07-2019 at 01:02 PM.